Production increase up to 56 ton/h

Production increase of an existing Rotary Hearth Furnace up to 56 ton/h for the reheating of steel ingots. The existing furnace was of a capacity of 40 ton/h. The revamping was based on the installation of regenerative burners on the heating zones increasing the heating capacity allowing to increase production rate. Besides the production increase, the system also obtained lower specific fuel consumption per produced ton thanks to the regenerative technology.

Main details

  • Capacity: 56 ton/h
  • Dimensions: 20.000 mm (outter diameter)
  • Fuel: Natural Gas
  • Country: Spain

Featured details

Complete design of the furnace revamping on a turn key supply basis
Installation of regenerative burners Ultra Low NOx, high heating transfer and higher energy efficiency
Production increase and lower specific fuel consumption
Natural gas as main fuel

Scope of supply

Heating equipment with regenerative burners
Control equipment by PLC and Level 2

Auxiliary equipment